CPI 3180 Series, Инструкция по сборке

Страница: 6 / 21

4096-668
CPI Satcom & Antenna Technologies 1.8M Ka-BAND Rx/Tx ANTENNA
1.4 SUGGESTED TOOL LIST
The following tools are suggested for the antenna installation.
HARDWARE SIZE SAE WRENCH SIZE METRIC WRENCH
SIZE
MAXIMUM REC.
TORQUE
1/4" BOLT
7/16" 11mm 6.5 ft-lbs
5/16" BOLT 1/2" 13 mm 12 ft-lbs
1/2" BOLT 3/4" 20 mm 45 ft-lbs
3/4" BOLT 1-1/8” 29 mm 145 ft-lbs
NOTE: The Minimum Torque applied should not be less than 10% of maximum recommended torque.
1.5 MECHANICAL ALIGNMENT TOOLS
The following tools are suggested for the initial alignment to the satellite.
1) COMPASS
2) INCLINOMETER
3) 10" CRESCENT WRENCH
4) SCREWDRIVER, STANDARD BLADE
1.6 SITE SELECTION
In order to achieve maximum performance of your antenna system, it is important to select the correct
location for the antenna. The following guidelines should be observed when selecting a site for the instal-
lation.
1. The line of site to the satellite should be clear of any obstructions, such as trees or buildings.
2. The site should be relatively flat and level for ease of installation and access to the antenna.
3. The site should be checked for underground obstruction, such as buried cables or pipes.
4. All local building codes should be adhered to (i.e. grounding, foundation requirements, zoning
rules, setbacks, etc.).