4096-668
CPI Satcom & Antenna Technologies 1.8M Ka-BAND Rx/Tx ANTENNA
3.
Attach the elevation adjustment rod (Item #4) to the elevation mounting bracket of the
reflector support with the elevation pivot sleeve, ½-13 x 1.75-inch bolt, two flat washers, and
hex nut (Items #6, 8, 9, 10, 11).
4.
Raise the reflector support until the elevation adjustment block is aligned between the
mounting plates at the back of the AZ/El assembly.
5.
Install a ¾-10 x 1.50-inch bolt, flat washer, and lock washer (Items #12, 14, 15) from each
side of the assembly.
1/2-inch Hardware and
Pivot Sleeve
(Items #6, 8, 9, 10, 11)
Elevation Adjustment
Rod Assembly
(Item #4)
Elevation
Adjustment
Block
3/4-inch Hardware
2 Places
(Items #12, 14, 15)
