4096-668
CPI Satcom & Antenna Technologies 1.8M Ka-BAND Rx/Tx ANTENNA
2.0
ANTENNA ASSEMBLY
Follow the steps below in the order shown to assemble the antenna. Because of the weight and
size of some of the antenna components, a minimum two person crew is recommended. Do not
tighten any hardware until instructed to do so.
Installing the AZ/EL assembly onto the mast pipe
1.
Use a ½-inch open-end wrench to loosen the eight canister set screws until they are flush with
the inside wall of the canister.
2.
Lift the AZ/EL assembly (Item #3) and slide the canister over the top of the mast pipe.
3.
Rotate the AZ/EL assembly until the reflector side is oriented in the general direction of the
satellite as shown.
4.
Snug the eight canister set screws enough to prevent the assembly from rotating. Do not
tighten until instructed to do so later in the assembly.
Toward
Satellite
1/2-Inch Set Screws
Typical 8 Places
AZ/El Assembly
(Item #3)
Mast Pipe
Canister
