Covidien Genius 3, Руководство по эксплуатации

Страница: 12 / 350

en
Tympanic Thermometer and Base 10
Table of Contents
Directions for Cleaning:
Genius 3 Thermometer Body, Base, and Coil Cord:
While cleaning the Genius 3 thermometer body, a probe cover should be installed on the thermometer. This will prevent
damage to the probe tip and probe lens. Clean the surfaces of the thermometer body, base, and coil cord with a damp cloth
using a mild detergent as previously described, removing all visible soil. Ensure all excess fluid is squeezed from the cloth before
cleaning. If the cloth is excessively wet, the detergent and water solution may penetrate the thermometer and affect functionality.
After cleaning the thermometer body, base, and coil cord wipe the thermometer with a clean lint free damp cloth to remove the
mild detergent mixture. Dry the thermometer with a clean lint free cloth. Never use an abrasive pad or an abrasive cleaner on the
Genius 3 thermometer, base, or coil cord.
Genius 3 Thermometer Probe Tip and Lens:
The thermometer probe tip and lens can be cleaned using a 70% isopropyl wipe such as Webcol™*, Curity™* or equivalent.
Carefully remove all foreign matter from the thermometer probe tip and lens. After the foreign matter has been removed, dry
the lens at the end of the thermometer probe tip with a lint free swab, cotton ball, or lens wipe. The thermometer lens must
be free from fingerprints and / or smudges for proper operation. After cleaning the thermometer probe tip and lens, allow the
thermometer to air dry completely.
Disinfection
Genius 3 Thermometer Body, Base, Coil Cord, Probe Tip and Lens:
The Genius 3 thermometer body, base, coil cord, probe tip, and lens can be disinfected by dampening their surfaces with
70% isopropyl alcohol.
Disinfection frequency:
It is necessary to disinfect the Genius 3 thermometer after each use.
Directions for Disinfecting the Thermometer Body, Base, Coil Cord, Probe Tip, and Lens:
Dampen the surfaces of the devices using isopropyl wipes such as Webcol™*, Curity™*, or an equivalent lint free wipe wetted with
70% isopropyl alcohol. Wipe the devices as necessary to maintain visual wetness for a minimum duration of 1 minute. Ensure that
the thermometer lens is free from fingerprints and / or smudges for proper operation. After disinfecting the thermometer probe
tip and lens, allow the thermometer to air dry completely.
Caution: The Genius 3 Tympanic Thermometer and Base is a non-sterile device. Do not use ethylene oxide gas, heat, autoclave,
or any other harsh method to sterilize this thermometer.
Caution: The Genius 3 Tympanic Thermometer and Base are not designed to be immersed, soaked, rinsed, or sprayed with water.
Do not immerse, soak, rinse, or spray the Genius 3 Tympanic Thermometer or Base in water or other cleaning solutions. Failure
to follow the cleaning procedures described herein could result in hazards to users, patients, and clinicians. As with any medical
electrical equipment, care must be taken to prevent liquid from entering the thermometer to avoid electrical shock hazard, fire
hazard, or damage to the electrical components.
Caution: If leakage into the thermometer interior occurs, do not use the thermometer until it has been properly cleaned,
dried, and checked for accuracy. Accuracy can be verified with the Genius Checker/Calibrator. For assistance please contact
Customer Service.
Section VII — Battery Replacement
The batteries (3 AAA) should be changed when the low battery icon appears on the display. After the low battery icon is shown,
about 100 readings can be taken before the dead battery display will appear. Once the dead battery display is shown, no more
readings can be taken.
To change the batteries, remove the cover on the bottom of the unit. Note the polarity of the installed batteries. Remove the old
batteries and replace with new, using the correct polarity. Replace the battery cover and secure it with the screws.