COVANA OASIS, Руководство по установке

Страница: 29 / 62

INSTALLATION MANUAL INSTALLATION 29
AC light kit installation
If your COVANA cover came with a light kit, follow
the steps below. If not, skip to next section, Lifting
mechanism assembly (continued).
1) Before splitting the cover into two pieces, fully
unscrew any bolts on all four corners that fasten
the outer shell to the inner shell if needed.
2) Locate the light switch button. (Figure 59)
3) Lift and split the long side of the outer shell
opposite the light switch button for the next
steps. To split the cover into two parts, you must
remove the outer shell by pushing inwards on
the steel frame of the inner shell. (Figure 59 and
Figure 60) This will clear the metal inserts from
the outer shell for better leverage.
Do not lift
more than 16 in (40 cm).
Note: A non-abrasive or blunt tool may be used
to help hold the outer shell in place before
following the next steps.
CAUTION

Do not use any sharp or abrasive tools to hold the
outer shell in place while following the next steps.

You should always hold the outer shell on the
long side at two different points spaced by about
85 cm [34
”]
WARNING

Do not lift corner more than 16 in (40 cm), further
lifting will damage the outer shell.

Failure to follow this instruction will cause
permanent damage to the outer shell.
Steel frame
Outer shell
Lifting direction
Metal inserts
Light switch button
location
S
ho
rt s
ide
Long side
Lift this side
Figure 59
Figure 60