COVANA OASIS COVER, Руководство пользователя, Страница: 35 / 82

OASIS COVER page-
33
FIGURE 45: CLIP-ON BARREL NUT INSTALLATION
ID DESCRIPTION
A CLIP-ON BARREL NUT
B M6 SCREW
C 1/4'' NYLON FLAT WASHER
19. Slide the sleeves over all four jacks see
Figure 46 .
NOTE
Be sure to align the cutouts at the bottom of the
sleeves with the U-frames.
FIGURE 46: SLEEVE INSTALLATION
20. Fasten the sleeve with the Phillips M6 x 20
mm screws at the bottom of all four sleeves
see
Figure 47 .
CAUTION
Make sure that the nylon washer is located on the
outside of the outer sleeve.
FIGURE 47: MOUNTING SCREW ON THE SLEEVE
21. Make sure the sleeve seal on each post is slid
all the way down against the top of the outer
sleeve see
Figure 48 .
WARNING
Failing to properly position this seal may cause
serious damage to the post mechanism.
FIGURE 48: SLEEVE SEAL INSTALLATION
22. Install the 3/8″ x 1″ Allen screw with a 7/32″
(5.5 mm) socket previously removed from the
jacks, with the smaller diameter of the
bushing facing down for each post see
Figure
49 .
241146 OWNER'S MANUAL REVISION 1