COVANA OASIS COVER, Руководство пользователя, Страница: 32 / 82

page-
30
OASIS COVER
FIGURE 38: SCREW INSTALLATION
6. Repeat previous steps with the non- motor
right-hand side foot.
CAUTION
Posts will fall easily when installed upright with the
foot installed. Secure the posts by laying them
down before proceeding with next step.
7. Position the left non-motor-side jack in the
remaining corner of the cover. The square
shaft at the bottom of the jack should face
toward the motor frame, and the U- frame
bracket should be inwards. If not, review the
previous steps to install the left and right post
feet.
8. Slide the drive shaft over the square shaft
located at the bottom of the left motor-side
jack assembly see
Figure 39 .
NOTE
The drive shafts are in the two long U- frames.
Remove the plastic film to locate them.
FIGURE 39: DRIVE SHAFT INSTALLATION
9. Hold the left- hand non- motor- side jack
assembly upright and in line with the left drive
shaft. Use a 3/4″ adjustable wrench to
carefully rotate the square shaft of the jack to
align with the drive shaft
Figure 40 .
CAUTION
Make sure the drive shaft is fully installed before
proceeding further in the installation process.
Using the jack without the drive shaft properly
connected may cause injury.
FIGURE 40: DRIVE SHAFT INSTALLATION
10. Install the long aluminum U-frame over the
left drive shaft and make sure it lines up with
motor- side
and non- motor- side jack
assemblies. Fasten in place using two
hexagonal 5/16″-18 x 2″ screws, two 5/16″-18
nylon-insert lock nuts and four 5/16″ plastic
washers (2 by side), with the 1/2″ (13 mm)
socket wrench and spanner as tools see
Figure 41 .
241146 OWNER'S MANUAL REVISION 1