COVANA OASIS COVER, Руководство пользователя, Страница: 34 / 82

page-
32
OASIS COVER
FIGURE 43: SHORT U-SHAPE INSTALLATION
15. Check whether the drive shafts fell off during
installation. If so, review the previous steps.
If not, tighten all U-frame screws.
DANGER
Failure to verify the proper installation of the drive
shafts could result in the non- motor- side jacks
extending on their own.
16. Once all the drive shafts are installed, the
jack lock screws located at the top of the non-
motor- side jacks can safely be removed.
Remove the Allen M8 x 50 mm screws and
keep them for future use see
Figure 44 .
WARNING
Failure to remove the locking screws will damage
the lifting mechanism when operating.
Do not remove the alignment bracket on the top of
the jack.
FIGURE 44: JACK LOCK SCREW
ID DESCRIPTION
A M8 x 50mm JACK LOCK SCREW
B 3/8″ x 1″ SOCKET HD SCREW
C BUSHING
D ALIGNMENT BRACKET (RED)
17. Unscrew the 3/8″ x 1″ Allen bolt with a 7/32″
(5.5 mm) socket on the top of all four jack
assemblies. Put these parts in a safe location
see
Figure 44 .
18. Install the clip-on barrel nuts at the bottom of
the non-motor-side jack assemblies to hold
the sleeves in the bottom. Use Phillips M6 x
20 mm screws and 1/4″ nylon washers. Only
the non-motor-side jack assemblies need clip-
on barrel nuts to be installed see
Figure 45 .
NOTE
Do not fully screw in the M6 screws; a gap is
needed to slip on the sleeves.
241146 OWNER'S MANUAL REVISION 1