Operation 6
Risk of electric shock . Can shock,
burn or kill. Do not handle a pump or pump
motor with wet hands or when standing on wet
or damp surface, or in water.
1. Shaft seal depends on water for lubrication.
Do not operate pump unless it is submerged
in water as seal may be damaged if allowed to
run dry.
2.
Risk of sudden starts . Can cause
electrical shock and personal injury. Motor
is equipped with automatic reset thermal
protector. If temperature in motor should rise
unduly, switch will cut off all power before
damage can be done to motor. When motor
has cooled sufficiently, switch will reset
automatically and restart motor. If protector
trips repeatedly, pump should be removed and
checked as to cause of difficulty. Low voltage,
long extension cords, clogged impeller,
very low head or lift, or a plugged or frozen
discharge pipe, etc., could cause cycling.
3. Pump will not remove all water. If operating a
pump manually, and suddenly no water comes
out of the discharge hose, shut off the unit
immediately. The water level is probably very
low and the unit has broken prime.
Risk of electric shock . Can
shock, burn or kill. Before attempting to check
why unit has stopped operating, disconnect
power from unit.
2 Slip the float and then the rod stop
onto the rod past the nib.
1 Mount the bracket on the switch
housing.
4 Attach the switch to the discharge pipe
as shown. The bottom of the bracket should
be 7-1/4” above the top of the volute for
correct on/off points (see below).
Vertical Switch Replacement
Rod
Rod Stop
Float
Bracket
Bracket
Mounting
Screws
Switch
Housing
Pin
3 Insert the rod assembly up into the
switch housing and lock into place
with the pin.
NOTICE Be sure the pin holds the
rod in the switch housing or the pump
will not shut off.
6110 1009
7-1/4”
NOTICE See instructions included with replacement switch, Part Number FPS17-66.
Содержание CLRP50
Страница 16: ......
