FLAME
回
Control Flame speed.
S Settings: (Vl-V2-V3-V4-VS) Flame speed from Vl to VS . VS is the fastest
SPEED
setting.
Control the Heater.
Press button to initiate the heater.
HEATER
回
(OFF) no heater or blower.
(-), heater blows warm air(750W)
(--), heater blows hot air(1500W)
NOTE: Heater functions cycle from (OFF) (-)(--)
Style A :
Control the flame color.
4 Settings: 1-red, 2-yellow, 3-orange, 4- blue.
回
Style B:
COLOR A
Control the top decor light color.
3 Settings: 1-red, 2-orange, 3-blue.
NOTE: W hen you press the button for 6 seconds until you hear a beep, the
indicator will show digital "O", the flame color and brightness will be changed
automatically.
Style A :
Control the flame bed color.
4 Settings: 1-red, 2-yellow, 3-red, 4-orange.
圈
Style B:
COLOR B
Control the flame and flame bed color.
3 Settings: 1-red, 2-orange, 3-blue.
NOTE: W hen you press the button for 6 seconds until you hear a beep, the
indicator will show digital "O", the flame color and brightness will be changed
automatically.
WARNING :Do not move or remove the mesh trim panel, when the appliance is plugged in and operating. This
will cause the remote control and touch panel to no longer function.
NOTICE: When the heater is first turned on, a slight odor may be present. This is normal and should not occur
again unless the heater is not used for a long period of time.
NOTICE: To improve operation, aim the remote control at the front of the fireplace. DO NOT press the buttons
too quickly. Give the unit time to respond to each command.
4.3 REMOVE CONTROL
+Move the battery's transparent insulating piece away before using.
Battery Holde「
Remote
(REAR VIEW)
p
-勿
t
、`
Battery must be recycled or
disposed of properly. Check with
your Local Authority or Retailer
for recycling advice in your area.
PROBLEM
SOLUTION
1. Main Power supply switch is off. Turn the main power supply switch to "ON" position.
2. Circuit breaker has tripped.
Too many appliances on this circuit. Be sure that
electrical supply for this unit is an individual circuit.
3. Heater is unplugged from wall
Make sure the power cord is plugged into a functioning
outlet.
and properly grounded 15 Amp 120V AC electrical
Heater doesn't turn on
outlet.
with the power switch. 4. Power cord or power plug are
damaged.
Contact a qualified electrician to replace power cord.
5. Power outlet for power plug
Check the power outlet and replace with a new one.
prong is loose.
6. Loose wiring.
Check all wiring for loose connections. Contact a
qualified electrician.
Long-press the "DIMMER" button for 6 seconds, the
1. Heater switches in on, but Flame appliance will go into sleep mode. All the lights off, the
is not on.
heating function goes on. Long-press for 6 seconds
Heater is on, but no
again, the appliance will back to normal mode.
flame or low flame
intensity.
2. Flame Adjusting knob is at low
Turn the knob to maximum setting.
setting.
3. Loose wiring.
Check all wiring for loose connections. Contact a
qualified electrician.
14
15