Cosen C-325NC, Инструкция по эксплуатации

Страница: 67 / 110

OPERATING INSTRUCTION
SECTION 4
4-30
4.8 TEST RUN THE MACHINE
Test-running this machine can ensure good machine performance in the future. We suggest you run the
following tests on the machine before first use:
Testing machine performance:
Turn on the power and run a basic performance test after you finish installing the machine. Follow
these steps to test machine performance:
Step 1 –
Disassemble shipping brackets and bolts.
Step 2 –
Install roller table
Step 3 –
Turn on the relay switch in the control box.
Step 4 –
Elevate the saw bow. (If your coolant pump is in reverse and the machine cannot run,
please change the electrical phase.)
Step 5 –
After the saw bow ascends, extend the quick approach device.
Step 6 –
Remove the rust-prevention grease with cleaning oil or kerosene.
Step 7 –
Start the coolant pump
Step 8 –
Test these functions under manual mode:
vise clamping/unclamping
saw bow ascending/descending
feeding forward and backward.
4.9 CUTTING OPERATION
Step 1 –
Check before you cut
Power: Check the voltage and frequency of your power source.
Coolant: Check if you have sufficient coolant in the tank.
Hydraulic: Check if you have sufficient (at least two-thirds or higher) hydraulic oil.
Workbed: Check if there is any object on the feeding bed that may cause interference.
Blade: Check the blade teeth and make sure there is no worn out teeth along the blade.
Light: Check the work lamp or laser light (optional) and make sure there is sufficient lighting.
Roller: Check all the rollers on the front and rear workbed can roll smoothly.
Saw bow: Check the saw bow to see if it can be elevated and lowered smoothly
Step 2 –
Place your workpiece onto the workbed manually or by using a lifting tool e.g. a crane.
Caution: Before loading, make sure the vises are opened to at least wider than the width of the
workpiece.
Step 3 –
Position your workpiece.