Cosen C-325NC, Инструкция по эксплуатации

Страница: 22 / 110

GENERAL INFORMATION
Section 2
2-6
The saw wheel cover interlock switches located on the two wheel housings are used to assure
that the machine will stop whenever the wheel covers are open. This device is to protect users
from being cut by the running saw blades. The vise clamp switch is to assure firm clamping of the
workpiece. If the workpiece is not clamped properly, the saw blade is not allowed to run.
Among all these safety switches, some of them are used to protect the users and some of
them are used to prevent damage to saw blades, the workpiece and the machine itself, etc. We
have taken every precaution to prevent injury or damage and to provide safe and economical
operation of the machine.
Guard mountings:
The locations of all safety guards on the machine are indicated above. All of these protectors
should always be mounted on the machine whenever the machine is running. Users are not
allowed to move any of these elements under any circumstances except when servicing the
machine. However, even skilled service technicians still have to be very careful when performing
repairs or service on the machine with any of these protectors removed. It is the responsibility of
the user to make sure all these elements is not lost and damaged.
2.2.6 Specification of Electrical Equipment
Electrical equipment is very important to the control system. Your machine a new type
system designed for safety by our engineers. We describe briefly as follows:
GROUND DIAGRAM
PLC
UNIT
CONTROL BOX
MOTOR
PE
L3
L2
L1
MOTOR
ELECTRICAL CABINET
MOTOR
CHASSIS BODY
GROUND PLATE 1
GROUND PLATE 2
Transformer
DOOR