Cosen C-325NC, Инструкция по эксплуатации

Страница: 43 / 110

OPERATING INSTRUCTION
SECTION 4
4-6
4.3.3 Blade descend pressure and speed control panel
The part of control panel is where cutting pressure and saw bow descend speed can be adjusted.
1. Cutting pressure control knob
This pressure control knob is used to adjust
the cutting pressure of the blade.
Turning the knob clockwise increases the
cutting pressure.
To obtain a good cutting result, choose the
right cutting pressure by turning the knob until
it points to your material on the color chart.
Fig 4-2 Cutting pressure and speed control panel
2. Blade descend speed control knob
This knob is used to adjust the descend speed
of the saw blade.
Turning the knob clockwise increases the
blade descend speed.
Blade descend speed is a determining factor to
a good cutting time and quality cutoff surface.
Set the blade descend speed in accordance
with the cutting pressure control knob.
Also commonly known as the flow control
valve
4.3.4 Human-machine-interface (HMI) touch screen
This HMI touch screen displays operation messages so that the operator is able to understand the
system condition. It also provides different operating modes and selections for the operator to work
with. During a cutting job, the operator can still enter the system and make changes to the cutting
operation as needed.
Warning: Do not wipe or clean the screen with volatile solvents.
Warning: Do not overexert pressure on the screen. The touch screen is very sensitive; all buttons
on the screen just need a slight touch to operate.
Note: All range parameters in HITECH 5.7” are configured under the “manual” mode.