Corvalent Gator Mini-ITX, Руководство по установке

Страница: 30 / 71

Gator Mini-ITX – Installation Guide
BIOS EHCI Hand-off
Work around for OSes without hand-off support. The EHCI ownership should be claimed by the EHCI driver. The
Optimal and Fail-Safe default setting is
Enabled.
USB Mass Storage Device Configuration Screen
You can use this screen to select options for the USB Mass Storage Devices Configuration. Use the up and down
<Arrow> keys to select an item. Use the <Plus> and <Minus> keys to change the value of the selected option.
USB Mass Storage Device Delay
Set the value for the number of seconds that POST waits for the USB mass storage device after start unit command
is issued. The options are 10, 20, 30 and 40 seconds.
Emulation Type
Set the emulation type to Auto, Floppy, Forced FDD, Hard Disk or CDROM. If Auto, USB devices less than
530MB will be emulated as floppy and remaining devices as Hard Drive. Forced FDD option can be used to force a
formatted HDD device to boot as FDD (ex. ZIP Drive).
PCI/PnP Setup
Select the PCI/PnP tab from the ezPORT setup screen to enter the Plug and Play BIOS Setup screen. You can
display a Plug and Play BIOS Setup option by highlighting it using the <Arrow> keys.
Clear NVRAM
Set this value to allow the system to clear the NVRAM. The Optimal and Fail-Safe default setting is No.
Plug and Play O/S
Set this value to allow the system to modify the settings for Plug and Play operating system support. The Optimal
and Fail-Safe default setting is
Yes .
No The No setting is for operating systems that do not meet the Plug and Play specifications. It allows the BIOS to
configure all the devices in the system.
Yes The Yes setting allows the operating system to change the interrupt, I/O, and DMA settings. Set this option if the
system is running Plug and Play aware operating systems.
PCI Latency Timer
Set this value to allow the PCI Latency Timer to be adjusted. This option sets the latency of all PCI devices on the
PCI bus. The Optimal and Fail-Safe default setting is
64 .
32 This option sets the PCI latency to 32 PCI clock cycles.
64 This option sets the PCI latency to 64 PCI clock cycles. This is the default setting.
96 This option sets the PCI latency to 96 PCI clock cycles.
128 This option sets the PCI latency to 128 PCI clock cycles.
160 This option sets the PCI latency to 160 PCI clock cycles.
192 This option sets the PCI latency to 192 PCI clock cycles.
224 This option sets the PCI latency to 224 PCI clock cycles.
248 This option sets the PCI latency to 248 PCI clock cycles.
Allocate IRQ to VGA
Set this value to allow or restrict the system from giving the VGA adapter card an interrupt address. The Optimal
and Fail-Safe default setting is
Yes.
Yes Set this value to allow the allocation of an IRQ to a VGA adapter card that uses the PCI local bus. This is the
default setting.
No Set this value to prevent the allocation of an IRQ to a VGA adapter card that uses the PCI local bus.
Palette Snooping
Set this value to allow the system to modify the Palette Snooping settings. The Optimal and Fail-Safe default setting
is
Disabled .
22