CorroVenta A2 ES, Руководство пользователя

Страница: 35 / 45

© Corroventa Ltd. 2017.05 34 (43)
Fault finding
Symptom Probable cause Action
Room is not getting
dehumidifier/low
capacity. Depending on the situation,
the cause of the problem
can be either incorrect
installation such as
obstructed wet air hose,
clogged filter, incorrect
settings to the machine or
machine failure.
Begin trouble shooting as follows until the
problem is identified:
Check the installation
– verify that the wet
air hose is not obstructed, that the dry air
throttles are in their intended position and
that any hose used on the dry air side too is
not squeezed or clogged but that the air flow
seems correct.
If the air flow is weak, check and if necessary
replace, the process air filter.
Check the settings of the machine as follows:
First, check that the water symbol in the left
part of the screen is moving, an indication of
on-going dehumidification. If it is not
moving, check the control mode in the lower
left corner of the display. For continuous
drying, this should read MAN for manual
mode. If external hygrostat is connected and
used, HYG mode, check the setting of the
hygrostat. If RH, DEW or MIX control mode is
used, check the setpoint highlighted at the
center of the display and adjust as required.
Verify that the water symbol starts moving.
If the control mode and its settings was not
the problem, continue by checking the
capacity mode presented in the top right
corner of the default view. For maximum
water removal, the text should read “MAX”.
ECO mode is for minimizing energy
consumption per liter water removed and
the ΔX modes are used for, for instance,
drying of local, sealed of water damages.
If required, use right arrow button to step to
the capacity mode menu and change mode.
Follow instructions presented for adjustment
of wet air volume.