CorroVenta A2 ES, Руководство пользователя

Страница: 20 / 45

© Corroventa Ltd. 2017.05 19 (43)
Capacity Mode
The drying capacity of the CTR A ES can be optimized to
the given work and situation by use of three different
operation modes.
When set to MAX, maximum, the machine operates to
remove as much water as possible. When the full effect
of the machine is not required, it can instead be set to
ECO, eco-mode, where the energy consumption per
liter of removed water is minimized.
For local water damages where the dry air volume is
not required, the machine can be set to one of its
ΔX
modes where it operates to produce a smaller volume
of even drier air, something that will further increase
the speed of the drying process. The difference
between ΔX1 and ΔX2 etc., is the dry air volume where
ΔX1 has the lowest volume.
For use during pressure drying when the machine is
slaved to a turbine on a local network, the CTR A ES also
has a pressure drying mode, PRS, where it
automatically adjusts the wet air flow to produces as
dry air as possible.
MAX For maximum water removal
ECO For minimal energy consumption per
liter water removed
ΔX1, ΔX2.. For maximum ΔX, as dry air as
possible. Reduced air volumes
suitable for, for instance local, sealed
of water damages.
PRS Pressure drying mode that can be
used when the machine is connected
to a network and slaved to a turbine.
When the machine is installed and started up and
whenever the capacity mode is changed, the wet air
flow needs to be adjusted for optimum performance.
When the capacity mode is changed, the machine will
guide the user through the procedure as depicted to
the right.
If the wet air hose is long, it might be necessary to
reduce the dry air flow somewhat in order to achieve
the correct wet air volume. Normally however,
adjusting the wet air throttle is sufficient to achieve
required wet air volume.
When adjusting the wet air flow, adjust slowly the
throttle slowly and allow for the indicator to stabilize
before evaluating whether the adjustment was
sufficient or if further increase or decrease is required.