34 of 109
CORRADI S.P.A. - USER MANUAL - EXYL
2 - 04.2011
PRODUCTS
FEATURES
PRODUCT FEATURES
NON COMPLIANCE/ DEFAULT
GLAZING
For aluminum frames refer to the ALUMINIUM voice.
ERMETIKA
The temperature inside the protection hood can reach very high values, if exposed to direct sunlight during the summer. This
may result in bonding of the fabric if the awning is not handled for long periods. It is recommended to open and close the
awning on a frequent basis to avoid this problem.
If the fabric is rolled up for long periods creases and wrinkles may appear on the fabric. The fabric is made of PVC and its
nature is not comparable to a glass. It is necessary to keep the awning stretched for at least 48h to soften creases and
wrinkles.
In case of installation in areas affected by dust and wind (e.g. beach facing the sea) it is possible that the fabric may be
damaged losing the transparency due to the combined action of wind and sand.
To maintain a good efficiency on the awning and the locking device it is necessary to maintain the vertical runners clean as
shown in the maintenance chapter.
Make sure there are no obstructions that may impede the orderly movement of the awning. This may cause malfunction of
the locking devices of the awning.
If there is ice/snow runners should be cleaned thoroughly before operating the awning.
RUNNERS
After some time from the installation and if no periodic maintenance is performed on the runners, as indicated in the manual,
there may be noise in the runners and sliders.
Noise on the runners soon after the installation is is considered a default.
