33 of 109
CORRADI S.P.A. - USER MANUAL - EXYL
2 - 04.2011
IT
ALIANO
DEUT
S
CH
FR
ANÇ
A
IS
ESP
A
ÑOL
ENGLISH
PRODUCTS
FEATURES
PRODUCT FEATURES
NON COMPLIANCE/ DEFAULT
FLOOR
The floor may dent in collisions or falling objects and the implementation of concentrated loads on a small area, such as chairs
with wheels, high heels and ladders is not suitable.
The floor can scratch as a result of contact with small objects such as nails or stones present beneath the soles of shoes.
At the time of delivery, the floor may be different from that of the samples after exposure to light which causes a change in the
wood color.
FURNITURE
During the winter it should be protected from the weather. It should be cleaned before being sheltered for the winter.
If the furniture is used in a marine environment it should be washed periodically with fresh water to remove traces of salt.
Stainless steel features see STAINLESS STEEL voice
MOTORS
Electrical system: it must be performed by a licensed electrician who shall issue a certificate of conformity of the electrical
system.
The system has to have an appropriate degree of protection being installed outside. A licensed electrician is able to properly size
the system and choose the right components (adequate IP protection).
Any voltage drop or radio interference may result in loss of the limit switches of the engines. In this case it is necessary to
proceed with a new programming as indicated in the Manual.
STAINLESS STEEL
The components in stainless steel (AISI 304) require no maintenance. The appearance of micro-oxidation, most frequently in
maritime environments characterized by salt spray, does not affect the quality and durability of the product such oxidations are
believed to be normal. In case you need to remove these oxidized points you can use a steel wool or a metal bristle brush (in
stainless steel). The protective film of chromium oxide (autopassivation) will reset in a natural way with the only exposure to air,
without any intervention by the user.
ALUMINIUM
The presence of marks and scratches is considered a fault only if these are visible at a distance of 2 meters.
If the signs and/or dents are visible at a distance of 2 meters these are to
be considered a defect.
Do not use acid to clean the painted aluminum, but only mild soap and water.
FINISH
Orange peel: the surface of the coating film has an uneven look like orange
peel.
Blistering: bumps on the surface of the coating film in various sizes and
frequency.
Sagging of the outer layer: localized and well defined irregular
accumulations of coating products, in the form of rounded edges and
shallow that affect the outer layer.
Posting - Veneer: the coating film lifts from the substrate in
form of small flakes.
Porosity - Cissing: Small holes like craters or indentations in the surface of
the coating film, ranging in size: from small pinhole up to a diameter of up
to 1 cm.
Impurities in the outer and inner layers: the coating film has a rough and
irregular surface, easily perceptible to the touch.
Scrapings for interference: the coating film is damaged and
presents lesions of varying depth and extent depending on the cause.
