SCRN-530 Hardware Installation Guide | DOC-SCRN-530-HIG | 21 July, 2021 | Page 8
5. Connectors, SFP+ and Micro-USB Ports, and
Status LED
The SCRN
-
530 has connectors and a small form-factor pluggable SFP+ port, as shown
in
Figure 4
.
Figure 4 SCRN-530 Connectors and Status LED
5.1
Phoenix Power Cable Port
The SCRN
-
530 has a 48 VDC power connector for delivering power from a Corning
PSU6 DC Power Supply Unit or equivalent to the radio node. Plug the Phoenix power
connector from the power source cable into the power connector.
5.2
SFP+ Transceiver Port
The SFP+ Transceiver Port accommodates a compact enhanced small form-factor
pluggable (SFP+) network interface module. The hot-pluggable SFP+ supplied with
this SCRN
-
530, must be installed in the Transceiver Port. The LC connector, terminated
end, of the fiber pair of an ActiFi cable (or other approved fiber cable) is then
connected to the SFP+ LC Ports to provide fronthaul transport network access to the
radio node. Refer to
Section 16. SFP+ LED Indications
for more information.
5.3
Micro-USB Port
The Micro-USB port is completely disabled and is not available for general use.
5.4
Status LED
The STA (status) RGB tri-color LED indicates the state of the SCRN
-
530, with boot,
normal, disabled, fault, and SCRN
-
530 indications. When the radio node initially
boots, the LED cycles through a number of colors and flashing behaviors until the
radio node is fully operational.
Section 12. SCRN-530 LED Boot Sequence
describes the
STA LED indications.
