SCRN-530 Hardware Installation Guide | DOC-SCRN-530-HIG | 21 July, 2021 | Page 3
FCC Statements
Safety Precautions
Corning strongly recommends reviewing and adhering to the following cautions and
notices before installing and operating the SCRN-530.
Caution:
Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
RF Exposure Warning Statement:
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum 4
0
cm between the radiator and your body. This
transmitter must not be collocated or operating in conjunction with any other antenna or
transmitter unless authorized to do so by the FCC.
This device can be expected to comply with part 15 of the FCC Rules provided it is
assembled in exact accordance with the instructions provided with this kit. Operation is
subject to the following conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received including interference that may
cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
WARNING:
This warning symbolizes danger that may cause severe injury or death. Before installing or
servicing equipment ensure that you are aware of all hazards involved with electrical circuitry and become
familiar with applicable safety standards and national and local electrical codes and any other relevant
standards.
WARNING:
For Professionals & Trained Installers:
• The device is designed for wall mount or ceiling mount applications only in an enterprise environment.
• Installers are required to maintain RF safety distances of 40 cm during the course of installation process.
• Wall installation should be avoided, if a minimum safety distance of 40 cm cannot be maintained.
WARNING:
All electrical equipment must be properly grounded. Refer to national and local electrical codes
and any other relevant standards for electrical grounding information.
