SCF-6 Canister and Inline Splice Closures
Page 26
SRP 003-485 • Issue 6 • October 2006
5.13.2
Prepare closure cover
Step 1
Remove the red protection clips from
the closure cover and throw them
away (Figure 41).
Step 2
Apply one third tube of lubricant
along the gasket channel in the
closure cover (Figure 42).
KPA-0483
Figure 41 — Remove Clip from Cover
KPA-0486
Step 3
Install the cover gasket with the gasket notches inserted in the keys at the end of
the closure cover. Begin at the center of the cover and work towards both ends.
IMPORTANT:
Note that the cover gasket is longer than the channel. This is a design feature for
maximum performance. DO NOT CUT THE GASKET.
Step 4
Retain a small amount of lubricant for use later. Cover the gasket with the
remaining lubricant (Figure 43).
Figure 42 — Lubricate Gasket Channel
Figure 43 — Lubricate Cover Gasket
KPA-0485
KPA-0484
5.13.3
Install closure cover
Step 1
Center the cover over the end
caps with the key on the cover
gasket opposite the clip on the
end cap gaskets (Figure 44).
Make sure the end caps are inside
the end cap stops on each end of
the closure cover.
IMPORTANT:
Make sure that the clip on the
end cap gasket is not positioned
on the seam of the end caps
and is on the opposite side of
the end cap from the cover
gasket.
Figure 44 — Install Inline Cover
Key on Cover Gasket
