Cornelius Cascata180, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 20

© 2017, Cornelius Inc.
- 9 -
3. Push the unit until it is in place (leave its air outlet facing outside to ensure good ventilation, and
the device shall be at least 75mm away from left, right and rear panels for good heat dissipation
4. Connect the nitrogen infusion unit with coffee tower with hose. Cut the hose to obtain appropriate
length and attach it to the receiving port on unit and secure it reliably. Positions of nitro coffee
outlet, non-nitrogen coffee outlet and cooling pipe port are shown by labels. Exposed parts should
be covered with thermal insulation materials and erasable tape.
Connect nitrogen supply
1. Connect the gas inlet port to Nitrogen supply of which the pressure should be regulated at 40~70psi.
Close the main valve of the cylinder unit all the connections have been completed.
2. If nitrogen supply is depressurized in two stages, the on-board pressure detection probe of the
device may be used; in this case, regulate the readings on the depressurization gauge on nitrogen
cylinder to obtain 100psi and regulate that on secondary depressurization gauge to obtain 40~70psi.
Nitrogen pressure probe is located between the depressurization gauges in two stages.
3. Push the unit until it is in place and engage wheel brakes.
Danger
• Only pure food grade nitrogen (N2) is permitted.
• Do not disconnect the nitrogen supply hose before closing the main valve on the cylinder.
• Set nitrogen pressure correctly, and the pressure of intake nitrogen may not exceed 70 PSI.
• Do not expel gas directly in narrow places; instead the device must be used in a well ventilated area.
• Nitrogen cylinder is expected to be stored and used only in upright posture, so please do not put them
upside down.
• Please follow all necessary safety precautions during transportation and use of nitrogen cylinders.
Nitrogen cylinders are under high pressure and if damaged, they may cause extreme damages and even
death.
• Always store this nitro-coffee dispenser and nitrogen cylinders in places beyond the reach of children.
• This nitro-coffee machine and nitrogen cylinders are not expected to be used by children or persons
who are not familiar with these safety procedures.
• Do not remodel any part of this nitro-coffee coffee machine and nitrogen cylinder accessories.
Remodeling this device will invalidate the warranty and may result in personal injury or even death and
other dangerous situations.
Connect coffee supply
1. Pour the prepared cold-brew coffee into disinfected and clean coffee keg.
2. Tighten the lid of coffee keg and connect the keg to the nitrogen and liquid pipelines of the body
through white/black connectors respectively.
3. Place the coffee keg onto the weighing platform.
Nitro coffee
outlet
(sst barb) Cold brew
coffee
outlet
Tower
outlet
Tower
outlet