Cormach GEO 10, Руководство по обслуживанию

Страница: 30 / 44

30 Technical service manual
GEO 10
Standard programming (Standard configuration)
This procedure is used when the native configuration (factory programming) of the
radio modules needs to be restored.
After the channel is read as outlined in paragraph “Read” above, it is possible to write
data (Configuration) to the radio module.
1. Press the “STANDARD PROGRAMMING” button located in section “Radio Sensor”.
2. Wait for the message confirming that data was written successfully.
3. Press the “OK” button.
4. Perform a reading operation of the configuration of the radio modules to ensure that
the procedure was completed successfully.
“Channel” must be set to 40.
Operation with other radio aligners
If other aligners of the same type are installed in the same place, Hark Lock and head
channels need to be set to a channel other than number 40 as in standard program-
ming. For instance, a first aligner may retain the channel 40 setting, a second one may
be set to channel 30, and so on.
WARNING: You will need to switch off the central unit and heads of any other ali-
gners of the same type before programming the radio channels.
Hard Lock firmware programming
1. Press “OK” or the Hard Lock device button.
Fig. 24
2. Check the current firmware and bootloader versions available on the Hard Lock
device by clicking on .