corgrap SN40 Series, Руководство по эксплуатации и обслуживанию

Страница: 7 / 12

EYE PROTECTION
protection
ALWAYS be
to air suppl
to guard against
injury.
The employer and/or
protection
89/686/EEC
shielded spectacles
TO PREVENT
 Never
tool while
 Never
 Never
 Never
 Alway
 Do no
LOADING THE TOOL:
Move pusher backward
Loading
Release Pusher:
FASTENER LOADING
PROTECTION which conforms to ANSI/ CE specifications
against flying particles both from the FRONT
be worn by the operator and others in the work
supply, loading, operating or servicing this tool.
against flying fasteners and debris, which could
employer and/or user must ensure that proper eye
equipment must conform to the requirements
89/686/EEC, and provide both frontal and side protection.
spectacles and face shields alone do not provide
PREVENT ACCIDENTAL INJURIES:
ever place a hand or any other part of the body
while the air supply is connected.
r point the tool at anyone else.
Never engage in horseplay.
Never pull the trigger unless nose is directed at the
Always handle the tool with care.
not pull the trigger or depress the trip mechanis
Move pusher backward: Pull pusher to rear until latched.
Cover will open.
into notch on the top of magazine
assembly.
Loading Fasteners: Drop staple stick over magazine and
slide forward. Repeat until magazine
is loaded, allow enough space for
pusher to disengage the magazine
and cover to close. Approximately
1/2” (13 mm
Release Pusher: Pull and turn the
clockwise direction to release pusher.
7
specifications and provides
FRONT and SIDE should
work area when connecting
Eye protection is required
could cause severe eye
that proper eye protection is worn. Eye
requirements of the ANSI Z87.1 and
protection. NOTE: Non-side
provide adequate protection.
body in nail discharge area of
the work.
mechanism while loading the tool.
Pull pusher to rear until latched.
Cover will open. Pusher front will drop
into notch on the top of magazine
Drop staple stick over magazine and
slide forward. Repeat until magazine
is loaded, allow enough space for
disengage the magazine
and cover to close. Approximately
13 mm).
Pull and turn the knob in the
clockwise direction to release pusher.