Refer to Operation Instructions
FOUR TYPES
CONTACT TRIP –
IDENTIFIED BY BLACK
The common operating procedure
trip mechanism while keeping the
will allow rapid fastener placement
pneumatic tools are subject to recoil
unintentionally allowed to recontact
pulled) an unwanted second fastener
SEQUENTIAL TRIP-
IDENTIFIED BY NICKLE
The Sequential Trip requires the
makes accurate fastener placement
Sequential Trip allows exact fastener
described under “Contact Trip”. The
accidentally drive a fastener if the
holding the trigger pulled.
TRIGGER OPERATED-
INDENTIFIED BY
The Trigger Operated model is cycle by actuation of the trigger only. The model does not have a
Contact Arm and is intended for use only where a Contact Arm CANNOT be used to satisfy the
requirements of the application. The Trigger Operated tool will cycle
REMOTE FIRE
-INDENTIFIED BY NICKLE
(Standard for long magazines models with
Remote Valve RCVA1
DIRECTIONAL
Loosen screw as shown. Adjust to desired exhaust direction and tighten screw.
OPERATION
Instructions and warnings on pages before proceeding
TYPES OF OPERATION FOR THIS SERIES TOOL.
IDENTIFIED BY BLACK TRIGGER
procedure on “Contact Trip” tools is for the operator to contact
the trigger pulled, thus driving a fastener each time
placement on many jobs, such as sheathing, decking
recoil when driving fasteners. The tool may bounce,
recontact the work surface with the trigger still actuated
fastener will be driven.
IDENTIFIED BY NICKLE PLATED TRIGGER
the operator to hold the tool against the work before
placement easier, for instance on framing, toe nailing and
fastener location without the possibility of driving a second
The Sequential Trip Tool has a positive safety advantage
the tool is contacted against the work – or anything
INDENTIFIED BY BLACK TRIGGER
Operated model is cycle by actuation of the trigger only. The model does not have a
Contact Arm and is intended for use only where a Contact Arm CANNOT be used to satisfy the
requirements of the application. The Trigger Operated tool will cycle each time the trigger is actuated.
INDENTIFIED BY NICKLE PLATED TRIGGER
long magazines models with
Remote Valve RCVA1)
DIRECTIONAL EXHAUST DEFLECTOR
Loosen screw as shown. Adjust to desired exhaust direction and tighten screw.
5
proceeding to use this tool.
OOL.
contact the work to actuate the
time the work is contacted. This
decking and pallet assembly. All
bounce, releasing the trip, and if
actuated (finger still holding trigger
before pulling the trigger. This
and crating applications. The
second fastener on recoil, as
advantage because it will not
anything else – while the operator is
Operated model is cycle by actuation of the trigger only. The model does not have a
Contact Arm and is intended for use only where a Contact Arm CANNOT be used to satisfy the
each time the trigger is actuated.
EXHAUST DEFLECTOR
