Coretec VCX-4400-E, Инструкция по установке и эксплуатации

Страница: 4 / 38

Familiarization with the VCX4400 ­ E
The VCX-4400-E Video Encoder accepts one video and two data signals. The output
from the encoder is a stream of IP- packets. It also contains a fluorescent LED display to allow
monitoring of unit performance and to facilitate troubleshooting. The encoder has a
programmable reset, which prompts the re-initiation of the video stream as well as a reboot
command.
The VCX-4400-D Video Decoder accepts the signal from the network originally generated by a
VCX-4400-E video encoder. The unit effectively decompresses this data stream and re-creates
an analog waveform in NTSC (or PAL) video format. The unit supports the bi-directional data
transmission of two data sub-channels, corresponding to the encoder. The unit also features an
LED display. The decoder also has a programmable reset command, tied to errors in the
incoming video stream, as well as a reboot command.
Front Panel
VCX4400-E-H, Half Size Encoder
Back Panel
VCX4400-E-H, Half Size Encoder
Power
switch
-controls
the
unit power
Control Port
-Used to directly
communicate with
encoder to configure
settings
Power Supply
Refer to “Power
Interface” in
Table of Contents
Video Input
Refer to “Video
Interface” in table of
contents
Ethernet
Refer to “Ethernet
Interface” in Table
of Contents
2 Data Sub-
channels
Refer to “Com Port
Data Interfaces” in
Table of Contents