Coretec VCX-4400-E, Инструкция по установке и эксплуатации

Страница: 27 / 38

The IP address of the destination for the com port data is set by this command. A typical setup
would have an encoder and a decoder. The decoder would have a com port IP address that is the same as
the encoder. In addition, likewise, the encoder’s com port IP would be the same as the decoder. Notice
that the default com ports IP’s are the opposite of the default device IP’s.
Default:
Encoder com ports - 192.168.0.253
Decoder com ports- 192.168.0.254
Example Command: COM2IP 192.168.0.10 (points the com port data to an encoder,
decoder, or other device whose IP address is 192.168.0.10)
COM1PORT, COM2PORT (Com Port)
The com port selection is configurable. However, the default setting should be adequate for normal
operation.
Default:
Com port 1 - 5002
Com port 2 – 5004
Example Command:
COM1PORT 5010
(sets com port 1 to port 5010)
COM1RS422, COM2RS422 <0|1>
The com port data-format is configurable. The parameter is “0” or “1”, where “1” enables RS-422
and “0” enables RS-232 format.
Default: 0 (RS-232)
Example Command:
COM1RS422 0
(sets com port 1 for RS-232)
COMM PORT COMMAND – FURTHER EXAMPLES
The following examples set up com port 1:
COM1 1
– Enable com port 1
COM1BAUD 9600
– Set com port 1 baud rate to 9600
COM1RS422 1
– Set com port 1 mode to RS422
COM1PORT 5002
– Set com port 1 port to 5002
COM1PARITY E
– Set com port 1 parity to even
COM1IP 192.168.0.10
– Set destination address for data to 192.168.0.10
COMxTCP <0|1>
1= Use TCP, 0=Use UDP
COMxSERVER <0|1>
1 = server, 0 = client