User and Maintenance Manual
Hydraulic brake ID 800
Model ID 800 (disc th. 8 mm)
Model ID 800 (disc th. 12.7 mm)
Date: 2014/07/01
Revision: 1.0
www.coremo.it
Page
5
of
13
4.
Warnings
Failure to follow the instructions in this manual and on any plates attached to the
product exposes persons to risks and may cause damage to other equipment and
machinery.
˗
The product must not be used at an ambient temperature lower than -20 °C.
˗
The disc must be made of iron alloy (cast iron or steel) having a hardness in the range 190 to 220
HB.
The technical department of COREMO OCMEA can provide additional information in order to ensure
correct application and use of the product.
Dangers caused by a power failure
: A power failure will stop the brake from working. It is therefore
necessary to provide an uninterrupted power supply or, if the case requires, use suitable power failure
warning systems as a brake failure may cause personal injury and damage to property.
Danger of breakage during operation
: To reduce the risk of breakage during operation carry out the
periodic inspections shown in this manual.
Risks connected with changes in operating conditions
: The product is designed for the purposes stated
in this user and maintenance manual therefore the brake power supply pressure is indicated to ensure
that braking is always safe and reliable. The operating conditions also vary depending on the diameter of
the brake disc used; an equation for calculating the dynamic torque as a function of disc diameter is
given in this manual. It should be stressed that an error in calculation will result in a braking torque that
is different from the desired value and this may represent a risk to safety.
Residual risk
: Residual risk can be attributed to the operator not following all the procedures stated in
the user and maintenance manual and not giving due consideration to the warnings.
