User and Maintenance Manual
Hydraulic brake ID 800
Model ID 800 (disc th. 8 mm)
Model ID 800 (disc th. 12.7 mm)
Date: 2014/07/01
Revision: 1.0
www.coremo.it
Page
10
of
13
and taking any other precautions necessary before proceeding.
6.
The hydraulic fluid pressure must not exceed 120 bar and the brake must be powered using
only mineral oil hydraulic fluid.
Do not apply the brake without the disc positioned between the brake linings; failure to
follow this rule could result in fingers being crushed and other dangers in addition to
damage to the brake itself.
7.
BEDDING-IN:
The initial braking torque may be from 30% to 50% less than the rated value until
the brake lining adjusts to the disc.
8.
Operation
8.1.
Power supply of the safety component
The hydraulic fluid pressure of the hydraulic brake must not exceed 120 bar as already stated
in the previous chapter and the brake must be powered exclusively by mineral oil hydraulic
fluid.
The technical department of COREMO OCMEA can provide information, suggestions and
assistance for correct application and use of the brake.
The wrong power supply pressure produces a tangential force different to the value
stated in this manual; the braking torque exerted by the safety component will
therefore be different to the desired value and represent a risk to aspects of safety.
8.2.
Improper use
The products considered here must be used exclusively as described in chapter 5 of this
manual. Any other use is to be considered improper. The manufacturer declines all
responsibility for damage caused by erroneous or unreasonable use of the product.
Use of the product for purposes other than those stated in this manual may
compromise any aspect of safety.
