User and Maintenance Manual
“D” Caliper brake
Model D-M
Model D05
Model D1
Model D2
Model D3 and D3-ID
Date: 2013/07/01
Revision: 1
www.coremo.it
Pag.
7
di
14
Ignoring the heat produced during braking affects brake lining wear and may jeopardize
the safety of the operators and the reliability of the product. Since a brake can be used
for many applications, it is advisable to contact the technical department of COREMO
OCMEA for further explanation in this regard.
6.
Transport and storage
Personnel assigned to this work must wear suitable PPE such as gloves, safety footwear
and take any other precautions necessary before proceeding with transport, handling
and storage of the this part.
1.
Transport
: When handling it is important to bear in mind the dimensions and weight of each
single type of product as shown in the product drawing enclosed with this manual and in the
catalogue of the brake type in question.
2.
Storage
: When storing brakes it is important to bear in mind that a considerable weight is
concentrated in a small space. Personnel assigned to this work must wear suitable PPE
(safety footwear, gloves, and take any other appropriate precautions) in order to avoid the
risk of injury.
7.
Installation
THE BRAKE MUST BE INSTALLED WITH THE MACHINE OFF.
Personnel assigned to this work must wear suitable PPE such as gloves, safety footwear and
take any other appropriate precautions to ensure adequate protection and avoid the risk of
injury.
Before installation, remove the spacer between the pads. To remove this spacer, widen the
space between the pads, rotating the grub screw (Figure 1) using a n. 12 Allen key, after
loosening the nut (C61600) with a n. 36 key and the grub screw (C61728) using a 5 Allen key.
Once the spacer has been removed, proceed with the installation.
1.
Mount the brake on a rigid flat surface of the machine or on a support capable of withstanding
a certain tangential force as shown in Table 1.
