User and Maintenance Manual
“D” Caliper brake
Model D-M
Model D05
Model D1
Model D2
Model D3 and D3-ID
Date: 2013/07/01
Revision: 1
www.coremo.it
Pag.
4
di
14
Use
: Compliance with the assembly and maintenance instructions prevents not only costly down time
but also accidents due to incomplete knowledge of the product.
Rotating parts
: The caliper brakes are coupled mainly with rotating parts. In this case the moving parts
must be protected in conformity with the requirements of DIRECTIVE
2006/42/EC
and Italian Legislative
Decree
17/2010
or equivalent legislation in force in the countries in which they are used.
Power source for pneumatic brakes
: Use air not contaminated with oil or water and a 25 micron filter
with automatic condensation discharge.
Power source for hydraulic brakes
: Use mineral oil SAE/SO 46.
Friction material
: All COREMO OCMEA caliper brakes are fitted with friction material which is absolutely
free of asbestos and is declared as NON toxic/harmful in full observance of health and environment
regulations and laws. In any case it is better not to inhale dust produced by them and to wash hands
thoroughly before eating or drinking.
Oils, greases, lubricating components
: These are used in extremely limited quantities. Personnel
suffering from allergies to these substances are advised to wear gloves or use protective cream which
must be washed off thoroughly before eating or drinking.
Product markings
: All the data on the plates must always be kept legible. Use the data shown on the
plates when contacting the manufacturer for spare parts, information or assistance for example.
Disposal
: Worn brake lining pads and other materials of which brakes are made are classified as special
NON toxic/harmful products and therefore must be disposed of in accordance with the laws in force in
the countries in which they are used.
4.
Warnings
Failure to follow the instructions in this manual and on any plates attached to the
product exposes persons to risks and may cause damage to other equipment and
machinery.
˗
The product must not be used at an ambient temperature lower than -20 °C.
˗
The disc must be made of iron alloy (cast iron or steel) having a hardness in the range 190 to 220
HB.
The technical department of COREMO OCMEA can provide additional information in order to ensure
correct application and use of the product.
