User and Maintenance Manual
“D” Caliper brake
Model D-M
Model D05
Model D1
Model D2
Model D3 and D3-ID
Date: 2013/07/01
Revision: 1
www.coremo.it
Pag.
11
di
14
8.2.
Improper use
The products considered here must be used exclusively as described in Chapter 5 of this
manual. Any other use is to be considered improper. The manufacturer declines all
responsibility for damage caused by erroneous or unreasonable use of the product.
Use of the product for purposes other than those stated in this manual may
compromise any aspect of safety.
9.
Maintenance and cleaning
ALL TYPES OF WORK ON THE BRAKE MUST BE DONE WITH THE MACHINE OFF.
Staff assigned to this work must wear suitable PPE such as gloves and safety footwear and take
any further precautions necessary to ensure adequate protection and prevent injury. Failure to
follow the instructions given for maintenance and cleaning of the product may compromise
personal safety and cause damage to equipment and machinery.
High temperatures may be produced after braking on the surfaces of the disc brake and
the brake linings. Personnel must therefore wait for parts subject to overheating to cool
down and wear suitable protective gloves and PPE.
9.1.
Readjusting the play
1.
Cut off pressure to the thruster, loosen the nut C61600 and grub screw C61728 (Figure 1).
2.
Rotate the play adjuster clockwise until the optimal play of 1 mm is obtained between the
disc and each brake lining (see Chapter 7 point 2).
3.
Lock the nut C61600 and the grub screw C61728 (Figure 1).
4.
Realign the brake shoes as described in point 3 of Chapter 7.
9.2.
Changing the lining pads and cleaning the friction surfaces
1.
Cut off pressure to the thruster.
2.
Remove the seeger rings C61275, then pull out the pin C61110 and remove the shoe
Z50263.
