10
CL33600 Series Cylindrical Lock
Copyright © 2009 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
1. Connect P3 (2-pin connector) from lockbody
to J3 on module (Fig. 11).
2. Connect P4 (6-pin connector) from lockbody
to J4 on module (Fig. 11).
3. Connect ElectroLynx harness (4 and 8-pin)
from door harness to ElectroLynx harness
on interior PCB assembly (Fig 11).
NOTES:
Neatly fold the wires onto themselves and into the remaining
space to prevent pinching wires when mounting escutcheon.
Do not tuck extra mortise lockbody wires back inside the lock
body cylinder hole.
Connectors go on only one way.
Do not offset connector and be sure they are completely seated.
5) Installation Instructions (Continued)
11. Connector Attachment (Interior PCB Assembly):
Fig. 11
J1
J2
To ElectroLynx
Harness
J5
From Reader
Board P5 to J5
PCB Layout - Wire Assignments - ElectroLynx Assembly (Molex)
J2
J1
1-Violet Lock Neg
(Solenoid, neg)
3-Pink
N/A
1- Black
PWR NEG
3-White
DATA 1
5-Orange
RX (NO)
7-Brown
EGND
2-Gray Lock Pos
(Solenoid, pos)
4-Tan
N/A
2-Red
PWR POS
4-Green
DATA 0
6-Blue
RX (COM)
8-Yellow
LED
12. Outside Wire Positioning
Please follow these steps prior to installing
inside escutcheon to prevent any damage
caused by pinching wires:
a. Once wires are arranged, position piece
at a rotated angle against the door, under
earth ground wire.
b. Press piece against door unwhile turning
clockwise (Fig. 12a).
c. Twist into place, perpendicular with door
(Fig. 12b).
Fig. 12A
Rotate Clockwise
Inside of Door
Fig. 12B
