Troubleshooting
Proble m
Possible Cause
Solution
9. Valve will not draw brine.
A) Low water pressure.
Fit pump (contact dealer).
B) Drain line restricted.
Check drain line is not blocked or
kinked.
C) Injector plugged.
Clean injector and screen.
D) Injector defective.
Replace injector.
E) Air check closes prematurely.
Put control into brine draw C2 to
check. Repair or replace if needed.
10. Uses more or less salt than A) Foreign matter in valve causing
Remove brine control and clean our
the setting.
incorrect flow rates.
any debris. Put system through a
regeneration to flush valve.
11. No water flow display on
A) Bypass valve in bypass.
Open bypass.
metered valves.
B) Meter probe not connected to
Connect correctly.
C) Restricted turbine rotation due to Remove turbine and clean. Turbine
debris in turbine.
should rotate freely, if not replace it.
12. Run out of conditioned water A) Impropper regeneration.
Repeat regeneration after checking
between regenerations.
the correct regenerant dosage is set.
B) Incorrect regeneration setting.
Set correct salt setting.
C) Incorrect hardness or capacity
Set to correct values.
settings.
D) Water hardness has increased.
Set hardness to correct value.
E) Restricted turbine rotation.
See 11 c.
F) No or not enough salt in cabinet. Salt level should be above water level.
