Cooper&Hunter CH-IRT05NM, Руководство по обслуживанию, Страница: 20 / 110

Rooftop Packaged Service Manual CONTROL
17
Enquiry and setting of wired controller‟s address is shown as Figure 2-3-4 below:
Figure 2-3-4 Enquiry
and setting of wired controller‟s address
3.2.3.2 Setting of Master/Slave Wired Controller‟s Address
Under off status of the unit, press Enter/Cancel and Mode buttons at the same time for 5s to go to the
enquiry and setting interface of master/slave wire
d controller. In this case, LCD displays wired controller‟s
address (01 for master wired controller and 02 for slave wired controller). Press ▲ or ▼ button to adjust
address of master/slave wired controller and then press Enter/Cancel button to confirm. If slave wired
controller is set, the icon will be displayed.
Note:
If there is only one wired controller, it only can be set as the master; If there are two wired controllers,
one should be the master and the other should be the slave.
Setting of master/
slave wired controller‟s address is shown as Figure 2-3-5 below: