Coolerado C60A, Руководство по установке

Страница: 5 / 53

Coolerado Installation
Page
5
of 53
SAFETY CONSIDERATIONS
Improper installation, adjustment, alteration, service,
maintenance, or use can cause explosion, fire, electrical
shock, or other conditions, which may cause death, personal
injury, or property damage.

Use this product only in a manner intended by
manufacturer.

Ensure the fan has completely stopped prior to
changing filters.

Before servicing or cleaning, other than changing
filters, ensure power to the unit is disconnected and
locked out.

Keep body, hands, and foreign objects away from air
intake while unit is in operation.

To avoid fire hazard, do not block any air intake.

Do not use the unit cabinet as a platform or storage.

Do not attempt to sit, stand, or climb on the unit.

Do not use the unit’s fan with any solid state speed
control device.
Consult a qualified installer, service agency, or your product
distributor for more information, or assistance. The qualified
installer or agency must use only factory-authorized kits or
accessories when modifying this product. Refer to the
individual instructions packaged with the kits or accessories
when installing.
WARNING: Follow all safety codes. Wear safety glasses,
protective clothing, and work gloves.
Read these instructions thoroughly and follow all warnings
or cautions included in literature and attached to the unit.
These instructions are intended as a general guide and do
not supersede local codes in any way. Authorities having
jurisdiction should be consulted before installation.
Recognize safety information, symbols and words:
(DANGER) will i dentify serious hazards, which will result in
severe personal injury or death.
(CAUTION) will i dentify unsafe practices, which would result
in minor personal injury or poor unit performance, product
damage and property damage.
(NOTE) will be used to highlight suggestions, which will
result in enhanced installation, reliability, or operation.
INSTALLATION RECOMMENDATIONS
NOTE: Any restrictions to air movement, either for intake
air, conditioned air, or exhaust air, will reduce the capacity
and efficiency of the unit.
NOTE: Working air (exhaust) will always be heavier than
ambient air until it fully mixes and comes to equilibrium
with outside air.
NOTE: Do not drill, cut, or compromise the powder coat
finish within the wet section of the unit. See Figure 19

The unit may be installed either indoors or outdoors.
Indoor installations require inlet air duct and
working air, (humid air exhaust), duct which may
increase costs and often add to static duct pressure
loss, create tight working spaces and require flexible
connections to allow future maintenance.

Flexible duct connectors should be installed between
any rigid ductwork and the unit to allow for leveling
requirement and to mitigate vibration. If the unit is
mounted indoors, a 2 ft. service area in front of the
Coolerado inlet fan plenum for servicing must be
designed for. The inlet air duct attached to this
plenum will need to be easily removable for
maintenance access.

Leave room for maintenance such as filter changing
on the C60 requires 25” on at least one side. If the
units are hung from the ceiling it can be difficult to
change filters.

If unit is installed indoors, install an emergency drain
pan that extends beyond the unit by at least 6” (152
mm) on all sides along with separate overflow drain
in accordance with local plumbing codes.

Be sure to provide adequate support for the unit and
associated ductwork.

Be sure that there is no exposure to flammable
vapors, excessive dust, or other contaminants in the
air.

To obtain the greatest cooling capacity, air will need
to flow into and out of the unit as freely as possible.

Humid working air must be allowed to flow freely
away from the unit and directed away from the