Coolerado C60A, Руководство по установке

Страница: 24 / 53

Coolerado Installation
Page
24
of 53
pollen, leaves, dust or insects, in which case the filters should
be inspected more often.
Inspect the filters periodically during the cooling season and
replace with new filters as required.
M30 Filter Changing Procedure:
1.) Turn off the fan toggle switch located in the top left
of the unit on the front face and wait until the fan
has come to a stop.
2.) Remove the filter access cover on the front of the
unit above the air inlet with the T-handles (may need
a Phillips head screw driver).
3.) Slide the top filter all the way to the top of the filter
frame. It should hold itself in place with a small clip
at the top. If it doesn’t then use a small piece of tape
to hold it in place. If the top filter doesn’t hold in the
up position, there is not enough room to hold it in
place with your hand and still get the lower filter
out.
4.) Slide the bottom filter up and pull the top towards
the fan and out of the unit.
5.) Slide the top filter down and remove it just as the
lower filter was removed.
6.) Reverse this process to re-install the filters.
7.) Re-install the filter access cover.
8.) Turn the fan control switch on.
M50B Filter Changing Procedure:
1.) Remove the filter access cover on the front of the
unit above the air inlet with the T-handles.
2.) Slide the top filter all the way to the top of the filter
frame. Pull the bottom of the filter towards the fan
and drop the filter until the top of the filter clears
the M50 cabinet. Lift the filter out of the unit.
3.) The middle and bottom filters can now be lifted up
and out of the filter frame.
4.) Reverse this process to re-install the filters.
5.) Re-install the filter access cover.
Side Mounted Working Air Exhaust Louvers:
If side louvers are installed, inspect the inside pad that
prevents water droplets blowing through the louvers. This
should be checked and replaced if filled with minerals. These
pads are used in some direct evaporative cooling units for
water distribution and are generally green in color.
C60A Filter Changing Procedure:
1.) Turn off the toggle switch located in the top left of
the unit on the front face and wait until the fan has
come to a stop.
2.) Remove the filter access cover on either side of the
unit.
3.) Slide the four (4) filters out the side.
4.) Re-install the filter access cover and turn the fan
control switch on.
M50B Outdoor Air Temperature and Humidity Sensor Filter
This filter is located behind the water control board and can
be accessed by removing the Filter Access Door, the top air
filter and reaching up behind the electrical box directly
behind the water control board, see figure 33. This can be
removed with a 7/16” deep socket or wrench.
Outdoor Air Temperature - Humidity Sensor Filter, Figure 33
Temp -
Humidity
Sensor
1/8" NPT
Compressed Air Muffler
Behind Temp - Humidity
Sensor Mounted on Board