4.
This manual was prepared at the time of manufacture of the device
and in accordance with the standards applicable at the time.
The company reserves the right to modify at any time the Installation
and User Guide to account for standards and their evolution.
Toavoidshortcircuits,pleaseturnoffthepower
at the electrical panel prior to installation or repair.
If the power cable is damaged, it must be replaced by the
manufacturer, its after-sales service personnel or a similarly
qualifiedpersontoavoidanydanger.
1 INSTALLATION
1. Free mounting bracket by pressing and pulling
both locking brackets inserted in the back of the
heater.
(No 1 in figure 2b).
2. Use the mounting bracket as a template by
holdingitagainstthewallflushtothefloor.Use
the hole shown as (
A Mark
on
Figure 2a
) to mark
the bottom fasteners location.
3. Raise the mounting bracket in order to match the
marks with the holes for the bottom fasteners.
4. Level the mounting bracket, mark and pierce the
4 holes for fastening.
5. Replace mounting bracket and fasten it with
screws.
USING THE MOUNTING BRACKET
AS A TEMPLATE FOR MARKING.
BRACKET
MARK
A
MARK
A
PEN
7-1/8"
180 mm
Figure 2a
HEATER INSTALLATION: This heater must be installed in
accordance with national and local codes and CONVECTAIR
recommends an installation by a qualified electrician.
!
NOTE
: If the installation is on a drywall and no studs are used,
CONVECTAIR recommends using anchors that will support a minimum
of 25 lbs (11.34 kg) each to install the mounting bracket.
