Controls WIZARD 2 50-C13A0X, Инструкция по эксплуатации

Страница: 72 / 120

Manuale di Istruzione
Instruction Manual
23/08/2018 Rev.1 EN
70
4.3 Carry out a test
The present chapter provides a quick guide for the execution of a test. Full details on the
various screens and options accessed are provided in chapter 4.2.
WARNING:
Be careful and use proper personal protection devices (e.g. gloves, protective shoes)
while loading/unloading samples from the test frame, due to the sample weight and sharp
surfaces.
WARNING:
Be careful and use proper personal protection devices (e.g. gloves, protective shoes)
while handling distance pieces and platens of the frame due to their weight.
WARNING:
Always close the front door and place the rear guard on the frame while executing the
tests. Also use proper personal protection devices (e.g. glasses) in order to avoid injures
due to fragments of samples ejected during the test (e.g. in case of test on explosive
samples).
WARNING:
If the TEST PARAMETERS value is not properly set, it will cause improper functioning
of the machine (e.g. if the value is too high the machine will not be able to sense the
failure of the sample and therefore will continue pressing the sample and never stop).
This may result in damages to the equipment and/or danger for the operator. CONTROLS
will not be considered responsible in these events.
WARNING:
Although the maximum speed of the loading piston of the frame is very low (max. 40
mm/min), to avoid injures during the compression phase, always close the front door and
place the rear guard while executing the tests. Also avoid putting hands/fingers in the gap
between the sample and the upper platen.
WARNING:
Before releasing the EMERGENCY BUTTON make sure that the lever of the hydraulic
ON/OFF valve is in the lower positions (discharge position).
WARNING:
Before turning the equipment OFF make sure that the lever of the hydraulic ON/OFF
valve is in the lower positions (discharge position).