11
during an alarm call how long the power has been out and if the power is currently on
or off. The factory default for the power out timer is 60 minutes.
Menu Option 6
To Review or Record Messages
You can record both a greeting and an alarm message on your Wireless WaterAlarm.
Each message can be 20 seconds long.
Greeting Message:
This message is played whenever you call your Wireless WaterAlarm from a remote
location. If there is no answering machine or voice mail, you may record a message
that indicates this machine does not accept messages and requests the caller to try back
later. If you do not record a personal Greeting Message, the factory default message is:
“
Hello, this is your Protected Home Alert System.”
Alarm Message:
This message is played whenever the Wireless WaterAlarm calls out
upon an alarm condition. It will precede the factory alarm messages and can be
programmed to contain personal information such as your name, address, etc. The
factory default message is:
Hello, this is your Protected Home Alert System.
Reinstating the Factory Default Message:
If you record a custom Greeting or Alarm Message but decide you would rather have
the factory default message instead, you can reinstate the factory default alarm or
greeting message.
1.
Select the menu option 6 to record messages
2.
Press 1:
To Review or Program the Alarm
(or
Greeting
)
Message
3.
Press 0 so you can change the Alarm or Greeting Message
4.
The Wireless WaterAlarm will begin playing the menu prompt below.
“
Begin Recording after the tone.
When you have finished recording, press the pound (#) key”
5.
While this message is playing, press the # key.
The menu prompt will stop
and the Wireless WaterAlarm will reinstall the factory default greeting or
alarm message.
2.3
Programming Your Wireless WaterAlarm Locally:
1.
Place the toggle switch on the front of the Wireless WaterAlarm in the
STANDBY position for programming. The ALARM light on the front of the
unit will begin flashing
2.
Plug a single line telephone into PROGRAM PHONE connector on the front
of the unit. This will be referred to as your Programming Phone. NOTE:
After programming is completed, unplug the Programming Phone from the
PROGRAM PHONE jack on the front of the Wireless WaterAlarm. If you
want to share a phone with your Wireless WaterAlarm in the same wall jack,
you will need a telephone jack line splitter. See Section 1.6,
Connecting
Cords, Sensor and Battery
for more information.
