Contec FXA3000 Series, Руководство пользователя, Страница: 91 / 113

6. Maintenance
84 FXA3000 Series
Initialization
There are two ways to initialize this product (recovering the factory settings).
- Using a Web browser
- Using the INIT switch of the main unit
Each initialization method is described below.
Using a Web Browser
Follow the procedure below when using Web browser to initialize the product.
(1) Follow the procedure below when using Web browser
to initialize the product.
(2) Select “Maintenance” - “Default setting” from the
menu.
(3) To leave the IP address of the product unchanged
without initialization, tick “Do not set IP address to
default”. To initialize the IP address, tick “Set IP
address to default” and then click “Default”.
(4) Click “Save/Reboot” on the menu to save the default
setting and reboot the product.
If the default setting is selected by mistake, click “Logout” on the menu to close the Web setup
screen.
Using the INIT Switch of the Main Unit
Follow the procedure below when using the INIT Switch of the Main Unit to initialize the product.
(1) The LEDs of POWER, LAN and WLAN
continue to blink for a little while after INIT
switch is pushed.
(2) Release this button after the LED starts
flashing but before it reverts to an ON state
(an interval of approx. 3 seconds).
(3) All the settings are restored to the default
settings after the product is started next time.
The flashing continues for a little while after the product is released during initialization by pushing
the INIT switch. This indicates internal memory files are being deleted. The internal memory files
may be damaged and the product may not start up properly if the power is switched off before the
flashing stops. Always reboot the product after the flashing stops.
CAUTION
INIT button
INIT
5VDC
10/100M
LAN
5-30VDC
Vi- FG Vi+
CAUTION