Contec FXA3000 Series, Руководство пользователя, Страница: 52 / 113

4. Setup and Status Display
FXA3000 Series 45
Preferred AP
This setting is available when the unit type is "Station" or "Repeater".
This setting is for when there are multiple access points that can be connected to and you wish to apply a
priority to the access points.
You can set the access point to preferentially connect to by specifying this setting. Enter the wireless
MAC address for the access points in "Preferred AP1" to "Preferred AP5".
For the priority of access points to connect to, "Preferred AP1" has the highest priority, "Preferred AP5"
has the lowest priority. This function is enabled by entering a valid wireless MAC address. When entering
MAC addresses, specify them in order from "Preferred AP1".
When not using this function, enter the MAC address "00-00-00-00-00-00".
Enter the MAC address as two characters, a hyphen, two characters, and so on. (Ex: 00-80-4C-00-00-00)
When the unit type is "Repeater", we recommend that you configure this setting and clearly specify the
connection destination in the settings for VAP2 (station) on networks with two or more repeaters. If you
do not specify the connection destination, when a chained repeater goes down, repeaters under it may
connect to repeaters even further below themselves and form a loop.
By clicking the button to the right of the entry form, you can display a list of wireless MAC addresses for
access points based on the "Wireless Node Information" in a drop-down list. By selecting an address from
this list, it can be entered in the form.
Default setting : 00-00-00-00-00-00 (all 1 to 5)
Connections to Non-Preferred APs
This setting is available when the unit type is "Station" or "Repeater".
When using the preferred AP function and the device cannot connect to the access points specified in
"Preferred AP1" to "Preferred AP5", set whether or not to allow connections to other access points.
To allow a connection to access points other than the access points specified as preferred APs, set this
setting to "Enable". To forbid connections, set this setting to "Disable".
When the unit type is "Repeater", we recommend that you set this setting to "Disable" and clearly specify
the connection destination in the settings for VAP2 (station) on networks with two or more repeaters. If
you do not specify the connection destination, when a chained repeater goes down, repeaters under it may
connect to repeaters even further below themselves and form a loop.
Default setting : Enable
Aging Time of the AP (sec)
This setting is available when the unit type is "Station".
Specify how long to keep the information of access points in the wireless node information.
If you want to change from the default setting, please perform sufficient validation in the system to be
used. You do not need to be changed in normal conditions of use.
Set this value between 10 and 120 seconds.
Default setting : 120
Time to Try Original Login (sec)
This setting is available when the unit type is "Station" and the WLAN infrastructure mode is “Standard
Infrastructure”.
Specify the time to try original login of the standard infrastructure.