Contec CONPROSYS nano CPSN-PCB271-S1-041, Справочное руководство, Страница: 151 / 155

—
Appendix
—
CPSN-PCB271-S1-041 Reference Manual (Software)
— 151 —
4. Push Switch (SW)
Operation Meaning
Start in recovery mode
Use this switch to recover the damaged firmware.
(Procedure)
(1) While pressing the push switch, turn on the power of the product.
(2) When PWR of LED is turned on and RUN is turned off, it indicates that the
product is operating in a recovery mode.
In the recovery mode, the IP address is the factory setting (10.1.1.101), and
the password is the value set for this product.
Initialize setting information Use this switch to initialize the setting information and log file.
(Procedure)
(1) Press the push switch when PWR of LED is ON.
(2) PWR, RUN, and STS of LED start flashing.
(3) The flashing lasts for 3 seconds. Release the switch while flashing.
(4) Wait until the PWR, RUN, and STS stop flashing.
(5) When the display of the PWR, RUN, and STS return to the original state, it
indicates the completion of initialization.