Contec CONPROSYS nano CPSN-PCB271-S1-041, Справочное руководство, Страница: 148 / 155

—
Appendix
—
CPSN-PCB271-S1-041 Reference Manual (Software)
— 148 —

CPSN-CNT-3201I
Item Contents Default
Operation mode 2-phase Input, Synchronous Clear, Multiply by 1,
2-phase Input, Synchronous Clear, Multiply by 2,
2-phase Input, Synchronous Clear, Multiply by 4,
2-phase Input, Asynchronous Clear, Multiply by 1,
2-phase Input, Asynchronous Clear, Multiply by 2,
2-phase Input, Asynchronous Clear, Multiply by 4,
Single-phase Input, Asynchronous Clear, Multiply by 1,
Single-phase Input with Gate Control, Asynchronous Clear,
Multiply by 1,
Single-phase Input with Gate Control, Asynchronous Clear,
Multiply by 2
2-phase Input,
Synchronous
Clear, Multiply by
1
Count direction CW direction Down-count, CW direction Up-count CW direction Up-
count
Phase-Z operation
mode
Disable phase-Z,
Only the next phase-Z input is enabled once,
Enable phase-Z always
Only the next
phase-Z input is
enabled once
Phase-Z input logic Positive-logic (active high), Negative-logic (active low) Positive-logic
(active high)
Digital filter *1
0.1 µsec, 6.52 µsec, 25.7 µsec, 32.1 µsec, 204.9 µsec,
211.3 µsec, 230.5 µsec, 236.9 µsec, 819.3 µsec,
825.7 µsec, 844.9 µsec, 851.3 µsec, 1024.1 µsec,
1030.5 µsec, 1049.7 µsec, 1056.1 µsec
0.1 µsec
One-shot pulse width
*2
0 µsec, 409.6 µsec, 819.2 µsec, 1.23 msec, 4.92 msec,
10.24 msec, 20.07 msec, 29.9 msec, 40.14 msec,
49.97 msec, 60.2 msec, 70.04 msec, 80.28 msec,
90.11 msec, 100.35 msec, 104.45 msec
0 µsec
Counter preset value *3 Set an arbitrary value to counter by using PLC program. 0
Counter comparison
value
Set a value to compare with counter by using PLC program. 0
Count operation Set an operating state by using PLC program.
Setting value : Stop, Start
Stop
The number of channels 1 channel -
Status detection Count match status -