Contec BUF-PCI(98), Руководство пользователя, Страница: 35 / 107

Setup
BUF-PCI(PC), BUF-PCI(98)
27
Running the BUF-PCI self-diagnostic program
Run the BUF-PCI self-diagnostic program following these steps.
(1) From the Windows Me Start button, select Programs.
(2) Select BUF-PCI self-test (VC) in CONTEC BUF-PCI.
(3) The self-diagnostic program runs and displays self-testing results
and resources assigned from the PC to the BUS-PCI(PCI).
Notes!
- The IRQ Level item is not displayed if you disable the use of
interrupt resources with DIP switch SW1 on the BUS-PCI(PCI)
board.
- If your personal computer does not support the MS-DOS OS,
DOSST.EXE as the self-diagnostic program for DOS might not run
correctly under the MS-DOS prompt.
- If self-testing results are not OK, see troubleshooting described later
in this manual.
Checking Resources
Follow the steps below to check the assigned resources managed by the
OS.
(1) Double-click on the [System] option in [Control Panel] to open the
[System Properties] property sheet. Select the [Device Manager]
tab.
(2) Click on the [Multi-function adapters] folder.
(3) Click on the [CONTEC Co., Ltd.-BUS-PCI(PCI)] folder to
display its properties.
(4) Select the [Resources] tab to check the device type, resource
settings, and the conflicting device list.
(5) If you want to change a resource setting, uncheck the [Use
automatic settings] option in advance. To change the I/O address
range (Input/Output Range), change the configuration name in the
[Setting based on:] field. Since the interrupt level (Interrupt
Request) cannot be changed, use the assigned IRQ.