TD SOLUS II:
Installation
19
La
st
r
ev
is
ed
0
5/
20
0
9
NOTE
Store all small parts carefully until they are required for
installation.
TIP
Installation is easier if you use 2 tension belts (not in-
cluded).
Fit the
100 x 100 foam strips
tightly around the cylinder
vertical ring and the
floor insulation
. Use adhesive on the
front faces:
Fit the
connection foam strips, pierced
over the connec-
tions:
Connect the two
side parts
on the side of the connection
pipes to one another:
Latch the terminal strip in the first hook first.
If the cut-outs in the sides for the pipe feed-throughs are
not quite centred, check the spacing between the vertical
ring and the floor again and adjust using the feet.
3-4 Clip the
plastic clips
to secure the terminal strip con-
nection.
Connect the other sides of the side insulation to one an-
other and secure them using the plastic clips to make in-
stallation easier:
Check: Side parts without offset at the top? (So that the
insulating foam lid can subsequently be fitted without
gaps.)
Latch the strip of hooks into the first hooks from top to
bottom.
Insert three short plastic clips onto the terminal strip be-
tween the four steel connections:
Check that the foam seal is evenly spread around the
insulating lid:
Fit the
insulating lid
so that it is in contact with the entire
surface of the side insulation and is gripped slightly. This
is particularly important for a tight seal:
Tighten all hook strips until the insulation is in tight con-
tact with the lid.
