© 2015 All rights reserved.
904568 Rev A CONMED ClearView™ Smoke Evacuation System Operator’s Manual
Page 7
1.4.1 WARNINGS:
• Read this manual thoroughly, and be familiar with its contents prior to using this equipment.
• Test this equipment prior to a surgical procedure. This product was thoroughly tested at the
factory before shipment.
• Disconnect the unit from the electrical outlet prior to inspecting system components.
• The ClearView™ Smoke Evacuation System is only intended and suitable for the applications
that are mentioned in the operating instructions.
• The smoke evacuator produces a strong vacuum. Adjust the airflow and the position of the
inlet end of the wand or tubing to prevent patient injury and to prevent suction of surgical
materials and surgical specimens.
• If the smoke evacuator is activated while the airflow is set to a high speed, it may produce a
sudden, strong suction action. Check the airflow setting before activating the smoke
evacuator to prevent patient injury and to prevent suction of surgical materials and
surgical specimens.
• To maximize patient safety, the tubing or wand should not come into direct contact with
tissue. Otherwise, patient injury may result.
• The CONMED filters and single-use accessories are completely disposable.
Please dispose of according to your local codes or regulations and hospital policy. These filters
may be disposed of or incinerated, whichever is appropriate for your institution.
• Care should be taken to route the power cord, foot pedal, smoke evacuation tubing, and
Automatic Activation Device cable as to not cause a tripping hazard or crimping of cords.
• Do not operate this device in the presence of flammable or explosive gases.
• To avoid risk of Electric Shock, this equipment must only be connected to a supply mains with
protective earth.
• This equipment is intended for use by healthcare professionals only. This equipment may cause
radio interference or may disrupt the operation of nearby equipment. It may be necessary to
take mitigation measures, such as re-orienting or relocating the ClearView™ or shielding the
location.
• The use of ACCESSORIES other than those specified by CONMED, or sold by CONMED
as replacement parts for internal components, may result in increased emissions or decreased
immunity of the ClearView™ Smoke Evacuation System.
• This equipment should not be used adjacent to or stacked with other equipment and that if
adjacent or stacked use in necessary, the ClearView™ Smoke Evacuation System should be
observed to verify normal operation in the configuration in which it will be used.
