Conel CLEAR DOS, Руководство по эксплуатации

Страница: 51 / 112

51
The built-in rotary flange for the dosing pump is equipped with bayonet holes. The necessary seals and
screws are pre-assembled on the dosing pump.
/ First flush the pipe with the newly installed built-in rotary flange. The built-in rotary flange is still sealed
by the black mounting cover.
/ Then shut-off the water again (at the stopcock or shut-off valve) and remove the black mounting cover
of the built-in rotary flange.
/ Insert the heads of the four M6×25 hexagon socket head screws through the bayonet holes on the
built-in rotary flange (see fig. 4 I).
/ Turn the dosing pump clockwise until it reaches the stop (see fig. 4 II).
/ Tighten the four M6×25 hexagon socket head screws.
The profile of the profiled flange gasket must point towards the built-in rotary flange (see fig. 5). If this is
not observed, water leaks may occur resulting in water damage to the home and furnishings and equip-
ment.
/ Unscrew the lid of the mineral solution container.
/ Remove the seal with a sharp knife.
/ Push the mineral solution container on from below over the suction lance and screw home on the pump
housing.
Do not undo the screws!
Select the tightening torque (about 4 Nm) so that the seal is effective and the dos-
ing pump is not damaged or strained!
Fig. 4: Dosing pump installation
Fig. 5: Built-in rotary flange
I II
Profiled flange gasket Flow direction arrow