Installation Instructions
Positioning module
Conductor rail program 0832, C-rail,
Console, ProShell
MV0800-0015a-EN
www.conductix.com
translated document
Page 7 of 23
2.2.3
Inserting/clipping the positioning band profile into the band holder
CAUTION!
Danger of cutting!
The following activities may result in injury due to cutting due to carelessness.
Wear suitable protective clothing such as gloves and work safety shoes.
The positioning band roller profile can "spring open" when unlocking. Avoid danger of injury
when unlocking the positioning band roller profile!
CAUTION!
Make sure that the positioning band profile is correctly aligned in the lane!
Before inserting/clipping in the positioning band profile, check the alignment of the positioning band
in the lane!
If necessary, turn the positioning band in the lane: The positioning band must be aligned
with the reader and the start code must be on the correct side of the Lane (see Chapter 6.3)
Installation variant
P0 (top)
Fig. 6: Clip in the positioning band profile
Fig. 7: The positioning band profile
is attached
Installation variant
P0
(bottom)
Fig. 8: Clip in the positioning band profile
Fig. 9: The positioning band profile
is attached
If the band holder has been
clipped in at the bottom of
the support profile, the
positioning band profile must
not be clipped in from
above.
This leads to a
deformation of the lower clip
of the band holder.
The positioning band profile
must be clipped in from
below.
After installation of the band holders and the positioning band profile, the positioning band profile must be easily and freely movable
in the X direction in order to be able to set the desired positioning range and to avoid displacement when the temperature changes.
