Installation Instructions
Positioning module
Conductor rail program 0832, C-rail,
Console, ProShell
MV0800-0015a-EN
www.conductix.com
translated document
Page 14 of 23
Fig. 23: Clipping in the positioning band profile
After installation of the band holders and the positioning band profile, the positioning band profile must be easily and freely movable
in the X direction in order to be able to set the desired positioning range and to avoid displacement when the temperature changes.
Pre-drill the positioning band profile on both sides as shown in the illustration and then screw it to the tensioning unit.
Fig. 24: Drilling the positioning band profile
The tensioning units are connected to the holding plates in order to tension the positioning band profile in a straight line.
